www.pruett-schaffer.com

PRODUCT NUMBER	PRODUCT NAME
63-1	SENSATIONAL SAND WATERBASED URETHANE-ACRYLIC

GENERAL DESCRIPTION Pruett-Schaffer’s #63-1 Sand Urethane is a very fast air-drying, self curing, water based, acrylic urethane coating. It is designed as a low gloss, spray or roll applied finish coat for general equipment and flexible substrates maintenance applications. It exhibits good film hardness and flexibility, and excellent water, solvent, and abrasion resistance. RECOMMENDED USES This product is recommended for maintenance use over various substrates including cold rolled steel, aluminum, plastics, composites, cement block and existing coatings. It will provide long term, cost effective protection against water, salt, oil, chemicals, and alkali cleaners. SURFACE PREPARATION At a minimum for acceptable performance, surfaces to be coated must be clean and dry, free of oil/grease, loose rust/paint, weld spatter, burning slag, dust, and chalk. Feather all rough or sharp edges. Existing coatings must be tightly adhering.	Some well-cured existing coatings may need to be deglossed by sanding or abrasion for this coating to develop its best adhesion; test patches should be made to determine if adhesion is adequate. THINNING Add water slowly with constant gentle agitation to a maximum of 5% by volume. APPLICATION EQUIPMENT Air assisted or airless spray application is preferred. Use a .017-. 020 inch tip. May be applied by brush or roller. Brushes should be of polyester or nylon construction. Rollers should have a nap thickness of ^1/4 to ^3/8 inch. Apply to 4-8 mils wet film thickness (2-3 mils dry film thickness). DRYING TIME Dries set to touch in 30 minutes and dries hard in 1 hour at 77 ^0F and 55% R.H. Force drying ovens may be used, do not exceed 250 ^0F; allow 15 minutes minimum for flashoff of solvent before heating. CLEANUP Clean equipment with room temperature soap and water before the film dries.	ENVIRONMENTAL This product meets current air pollution regulations regarding hydrocarbon and ozone reactive emissions. It is VOC compliant for most industrial applications, and contains no chromates, lead or free isocyanate. PHYSICAL PARAMETERS VOC, ASTM D-3960: .81 lb./gal NONVOLATILE: By weight: 52% By volume: 38.5% DENSITY, ASTM D-1475: 10.6 lb./gal THEORETICAL COVERAGE: 309 square ft/gallon @ 2mil, dry film INITIAL GLOSS, 60^0: 15-25 IMPACT RESISTANCE, ASTM D-2794: Direct: >160 in lb Reverse: >160 in lb ABRASION RESISTANCE, Taber, CS-17 wheel, 1000 g, 1000 cycles: 54 mg loss CHEMICAL RESISTANCE, ASTM D-1308: Acid, 5% H2SO4 pH 0.6, spot: no effect Base, 5% NaOH pH 13.5, spot: no effect Water immersion, 24 hr @ 70 ^0F: pass VISCOSITY, ASTM D562: 80-90KU FLASH POINT PENSKY-MARTINS :152F
THIS INFORMATION RESULTS FROM TESTS CONDUCTED IN A LABORATORY UNDER LABORATORY CONDITIONS. DIFFERENT RESULTS MAY BE OBTAINED IN COMMERCIAL USE OF THIS PRODUCT UNDER FACTORY OR FIELD CONDITIONS. PRUETT-SCHAFFER MAKES NO WARRANTY CONCERNING THE SUITABILITY OF THIS PRODUCT FOR THE END USE CONTEMPLATED BY THE BUYER, EXCEPT THAT THE PRODUCT SHALL BE IN COMPLIANCE WITH THE TECHNICAL SPECIFICATIONS PRESENTED HEREIN.

REVISED 05-13-2005