PRODUCT NUMBER	PRODUCT NAME
50-13344-1	BLACK ASPHALTIC VARNISH, MIL. SPEC. TT-V-51f

GENERAL DESCRIPTION Pruett-Schaffer’s #50-13344-1 is an air drying, solvent based, oil modified asphaltic varnish. It may be applied by brush, spray or roller. It exhibits good surface wetting properties for difficult to clean substrates and corrosion & water resistance. It provides a cost effective alternative to toxic coal tar based compounds for protecting steel , aluminum or concrete from normal environmental conditions. RECOMMENDED USES This product is recommended for general maintenance on steel or concrete structures wherever normal interior or exterior atmospheric conditions exist. It is designed for use as a corrosion preventative & waterproofing compound over concrete & metal substrates, both above & below grade, exposed to humidity, salt water, oil, weak acids & alkali. The coating is not normally topcoated & is not recommended for exposure to solvents, gasoline or other fuels. This formula complies in raw materials specifications & coating performance to Military Specification TT-V-51f.	SURFACE PREPARATION For best performance, new metal substrates should be clean, dry, & free of oil/grease. Concrete should have all form release oils, curing membranes & dirt removed. This coating is very tolerant of less than perfect surface preparation. Feather all rough or sharp edges. THINNING Under normal conditions no thinning is necessary. Adding thinner to this product will cause the product to be non-voc compliant by state law. APPLICATION EQUIPMENT May be applied by brush, roller, air-assisted, or airless spray. For airless spray use .015-.020 inch tip size. Brushes should be of polyester or nylon construction. Apply to 6-8 mils wet film thickness, to achieve 3-4 mils dry film thickness . DRYING TIME Dries set to touch in 3 hours at 70 ^0F. and hard overnite. CLEANUP Clean equipment with mineral spirits ,xylol or toluol before the film dries.	ENVIRONMENTAL This product contains no lead, chromate, or zinc. PHYSICAL PARAMETERS VOC, ASTM D-3960: under 350g/l WEIGHT PER GALLON, ASTM D-1475: 7.70 lbs NONVOLATILE: By weight: 62.4 +/- 2.0 % By volume: 51.7 +/- 1.0% THEORETICAL COVERAGE: 830 ft^2/gallon/mil, dry film INITIAL GLOSS, 60^0 , ASTM D-523: high-no other specification VISCOSITY, ASTM D562:brushable No viscosity range specified FLASH POINT, TAG CC: >86 ^0F TEST DATA IMPACT, ASTM D-2794: Direct: > 80 in-lbs Reverse: > 80 in-lbs ANTISAG INDEX, ASTM D-4400: >10 mils
THIS INFORMATION RESULTS FROM TESTS CONDUCTED IN A LABORATORY UNDER LABORATORY CONDITIONS. DIFFERENT RESULTS MAY BE OBTAINED IN COMMERCIAL USE OF THIS PRODUCT UNDER FACTORY OR FIELD CONDITIONS. PRUETT-SCHAFFER MAKES NO WARRANTY CONCERNING THE SUITABILITY OF THIS PRODUCT FOR THE END USE CONTEMPLATED BY THE BUYER, EXCEPT THAT THE PRODUCT SHALL BE IN COMPLIANCE WITH THE TECHNICAL SPECIFICATIONS PRESENTED HEREIN.

QC IDENTIFIER: E26

REVISED 2-07-2005