www.pruett-schaffer.com

PRODUCT NUMBER

PRODUCT NAME

36-33538

YELLOW TRAFFIC PAINT

 

GENERAL DESCRIPTION

 

Pruett-Schaffer’s #36-33538 Yellow Traffic Paint is a very fast air-drying, solvent based paint.  It is designed for spray application but can be applied by brush or roller. It has good hiding properties.

 

RECOMMENDED USES

 

This product is recommended for traffic striping in parking lots and garages. Because of its very fast dry, it can also be used as a dry fall coating for ceilings and walls. The medium oil alkyd vehicle is suitable for both interior and exterior atmospheric conditions. Not recommended for immersion service or for areas subject to severe chemical exposure.

 

SURFACE PREPARATION

 

Clean heavily contaminated areas of grease & oil with detergent solution. If used as a dry fall coating minimal preparation is required.

 

 

THINNING

 

Under normal conditions no thinning is necessary.  Thin if necessary for spraying with xylol.  Add a little at a time with constant gentle agitation to a maximum of 5% by volume.

 

APPLICATION EQUIPMENT

 

May be applied by brush, air-assisted, or airless spray.  Airless spray gives the best results, use .015-.020 inch tip size.  Brushes should be of polyester or nylon construction.  If applying with a cup type spray gun, thinning may improve application properties.  Apply to 2-4 mil dry film thickness  for longer service life.

 

DRYING TIME

 

Dries tack free in 10-15 minutes at 77 0F.

 

 

CLEANUP

 

Clean equipment with Mineral Spirits or xylol before the film dries.

 

ENVIRONMENTAL

 

This product contains no lead, chromate, or zinc.

 

PHYSICAL PARAMETERS

 

VOC, ASTM D-3960: 3.61 lb/gal

WEIGHT PER GALLON, ASTM D-1475:

10.30 lb

NONVOLATILE:

By weight:  64.9 +/- 2.0 %

 By volume:   42.2 +/- 1.0%

THEORETICAL COVERAGE:

677 ft2/gallon/mil, dry film

INITIAL GLOSS, 600 , ASTM D-523:

1-10

VISCOSITY, ASTM D562: 72-80 Krebs

FLASH POINT, TAG CC: 50 0F

 

 

TEST DATA

 

IMPACT, ASTM D-2794:

Direct: >10 in-lbs.   Reverse: > 2 in-lbs.

ANTISAG INDEX, ASTM D-4400:

>8 mils

 

 

THIS INFORMATION RESULTS FROM TESTS CONDUCTED IN A LABORATORY UNDER LABORATORY CONDITIONS.  DIFFERENT RESULTS MAY BE OBTAINED IN COMMERCIAL USE OF THIS PRODUCT UNDER FACTORY OR FIELD CONDITIONS.  PRUETT-SCHAFFER MAKES NO WARRANTY CONCERNING THE SUITABILITY OF THIS PRODUCT FOR THE END USE CONTEMPLATED BY THE BUYER, EXCEPT THAT THE PRODUCT SHALL BE IN COMPLIANCE WITH THE TECHNICAL SPECIFICATIONS PRESENTED HEREIN.

 

REVISED 11-04-2004