www.pruett-schaffer.com
|
PRODUCT NUMBER |
PRODUCT NAME |
||
|
36-27886 |
OFF-WHITE TRAFFIC PAINT |
||
|
GENERAL DESCRIPTION Pruett-Schaffer’s #36-27886 Off-White Traffic Paint is a very fast air-drying, solvent based paint. It is designed for spray application but can be applied by brush or roller. It is VOC compliant. It has good hiding properties. RECOMMENDED USES This product is recommended for traffic striping in parking lots and garages. Because of its very fast dry, it can also be used as a dry fall coating for ceilings and walls. The medium oil alkyd vehicle is suitable for both interior and exterior atmospheric conditions. Not recommended for immersion service or for areas subject to severe chemical exposure. SURFACE PREPARATION Clean heavily contaminated areas of grease & oil with detergent solution. If used as a dry fall coating minimal preparation is required. THINNING Under normal conditions no thinning is necessary. Thin if necessary for spraying with VM&P Naphtha or Toluol. Add a little at a time with constant gentle agitation to a maximum of 5% by volume. |
APPLICATION EQUIPMENT May be applied by brush, air-assisted, or airless spray. Airless spray gives the best results, use .015-.020 inch tip size. Brushes should be of polyester or nylon construction. If applying with a cup type spray gun, thinning may improve application properties. Apply to 2-4 mil dry film thickness for longer service life. DRYING TIME Dries tack free in 10-15 minutes at 77 0F.CLEANUP Clean equipment with Mineral Spirits before the film dries. ENVIRONMENTAL This product contains no lead, chromate, or zinc and is VOC compliant. PHYSICAL PARAMETERS VOC, ASTM D-3960:3.32 lb./gal |
WEIGHT PER GALLON, ASTM D-1475: 11.71 lbs. NONVOLATILE: By weight: 71.6 +/- 2.0 % By volume: 48.0 +/- 1.0% THEORETICAL COVERAGE: 772 ft2/gallon/mil, dry film INITIAL GLOSS, 60 0 , ASTM D-523: 1-10VISCOSITY, ASTM D562: 65-80 Krebs FLASH POINT, TAG CC: 50 0FTEST DATA IMPACT, ASTM D-2794: Direct: >10 in-lbs. Reverse: > 2 in-lbs. ANTISAG INDEX, ASTM D-4400:>8 mils
|
|
|
THIS INFORMATION RESULTS FROM TESTS CONDUCTED IN A LABORATORY UNDER LABORATORY CONDITIONS. DIFFERENT RESULTS MAY BE OBTAINED IN COMMERCIAL USE OF THIS PRODUCT UNDER FACTORY OR FIELD CONDITIONS. PRUETT-SCHAFFER MAKES NO WARRANTY CONCERNING THE SUITABILITY OF THIS PRODUCT FOR THE END USE CONTEMPLATED BY THE BUYER, EXCEPT THAT THE PRODUCT SHALL BE IN COMPLIANCE WITH THE TECHNICAL SPECIFICATIONS PRESENTED HEREIN. |
|||
REVISED 02-14-2001