PRODUCT NUMBER

PRODUCT NAME

20-54-1

WHITE STRIPING PAINT- 0VOC

GENERAL DESCRIPTION

Pruett-Schaffer’s #20-54-1 White is a latex paint designed for interior or exterior use as a marking paint. It is an acrylic copolymer with good scrub (abrasion) resistance, excellent sag resistance, good application properties & water resistance.

RECOMMENDED USES

This product may be used on all turf products, asphalt, concrete, dry wall, cinder block, concrete block and properly sealed wood. It is not recommended for application to metal surfaces.

SURFACE PREPARATION

This coating is very tolerant of less than perfect surface preparation, so chemical cleaning, high pressure washing, or even hand or power tool cleaning may be sufficient, depending on the level of service required. At a minimum for acceptable performance, all surfaces to be coated must be clean, dry, and free of oil and grease, loose paint, dust, and chalk.

THINNING

Under normal conditions, no thinning is necessary or desirable. Thin if necessary for proper spraying with water. Add water a little at a time with constant gentle agitation to a maximum of 5% by volume.

APPLICATION EQUIPMENT

This paint may be applied by air-assisted, or airless spray, roller, or brush. Apply 2-3 mils dry film thickness for full coverage.

DRYING TIME

Dries tack free in 15-30 minutes at 77 ^F and 50% Relative Humidity. Light handling may be possible in 30 minutes. High humidity will prolong dry time more so than low temperatures. To speed the dry time good air movement over the work and local exhaust is recommended. Heat lamps or forced warm air-drying will reduce dry time in cold conditions.

CLEANUP

Clean equipment with warm soap and water or water mxture before the film dries. Run ethyl alcohol through spray guns after cleaning to prevent corrosion of non-stainless steel parts.

ENVIRONMENTAL

This product meets current air pollution regulations regarding hydrocarbon and ozone reactive emissions. It contains no lead or chromate, and complies with current federal regulations regarding the use of lead in paint.

PHYSICAL PARAMETERS

VOC, ASTM D-3960:

.07 lb/gal

WEIGHT PER GALLON, ASTM D-1475:

12.6 lbs

NONVOLATILE:

By weight: 56.6%

By volume: 34.3%

THEORETICAL COVERAGE:

275 ft²/gallon @ 2-mils dry

INITIAL GLOSS, 60^, ASTM D-523:

0-10

VISCOSITY, ASTM D-562:

90-105 Krebs Units

pH RANGE, ASTM D-4584:

8.0-8.9

FLASH POINT, PENSKY-MARTINS CC:

> 141 ^F

THIS INFORMATION RESULTS FROM TESTS CONDUCTED IN A LABORATORY UNDER LABORATORY CONDITIONS. DIFFERENT RESULTS MAY BE OBTAINED IN COMMERCIAL USE OF THIS PRODUCT UNDER FACTORY OR FIELD CONDITIONS. PRUETT-SCHAFFER MAKES NO WARRANTY CONCERNING THE SUITABILITY OF THIS PRODUCT FOR THE END USE CONTEMPLATED BY THE BUYER, EXCEPT THAT THE PRODUCT SHALL BE IN COMPLIANCE WITH THE TECHNICAL SPECIFICATIONS PRESENTED HEREIN.