www.pruett-schaffer.com

PRODUCT NUMBER	PRODUCT NAME
20-35	YELLOW AUGER WATERBASED PAINT

GENERAL DESCRIPTION Pruett-Schaffer’s #20-35 Yellow is a fast drying, low gloss marking paint. It is an Acrylic blend with good film characteristics at a low cost. It is extremely low in VOC. RECOMMENDED USES This product may be used for temporary or permanent marking of steel or other substrates. It provides protection on interior surfaces not exposed to weathering or harsh environment. Although 20-35 does not contain rust inhibitors, the acrylic vehicle will prevent corrosion for up to 6 months on exterior exposure. SURFACE PREPARATION Apply as a direct-to-metal primer. At a minimum for acceptable performance, all surfaces to be coated must be clean, dry, and free of oil and grease, loose rust and paint, weld spatter, burning slag, dust, and chalk. THINNING Under normal conditions, no thinning is necessary or desirable. Thin if necessary	for proper spraying with an 80/20 mixture of water/butyl cellosolve ( Pruett-Schaffer Thinner #98-8937). Add thinner a little at a time with constant gentle agitation to a maximum of 5% by volume. APPLICATION EQUIPMENT This paint may be applied by air-assisted, airless spray, conventional or pressure pot equipment. DRYING TIME Dries tack free in 15-30 minutes at 77 ^0F and 50% Relative Humidity. Light handling may be possible in 30 minutes. High humidity will prolong dry time more so than low temperatures. To speed the dry time good air movement over the work and local exhaust is recommended. Heat lamps or forced warm air-drying will reduce dry time in cold shops. CLEANUP Clean equipment with warm soap and water or water/butyl cellosolve in an 80/20 mixture before the film dries. Run ethyl alcohol through spray guns after cleaning to prevent corrosion of steel parts.	ENVIRONMENTAL This product meets current air pollution regulations regarding hydrocarbon and ozone reactive emissions. It contains no lead or chromate, and complies with current federal regulations regarding the use of lead in paint. PHYSICAL PARAMETERS VOC, ASTM D-3960: .26 lb/gal WEIGHT PER GALLON, ASTM D-1475: 11.65 lbs NONVOLATILE: By weight: 48.4% By volume: 27.8% THEORETICAL COVERAGE: 445 ft^2/gallon @ 2-mils dry INITIAL GLOSS, 60^0, ASTM D-523: 0-15 VISCOSITY, ASTM D-562: 57-63 Krebs Units pH RANGE, ASTM D-4584: 9.0-9.9 FLASH POINT, PENSKY-MARTINS CC: > greater than 141 ^0F
THIS INFORMATION RESULTS FROM TESTS CONDUCTED IN A LABORATORY UNDER LABORATORY CONDITIONS. DIFFERENT RESULTS MAY BE OBTAINED IN COMMERCIAL USE OF THIS PRODUCT UNDER FACTORY OR FIELD CONDITIONS. PRUETT-SCHAFFER MAKES NO WARRANTY CONCERNING THE SUITABILITY OF THIS PRODUCT FOR THE END USE CONTEMPLATED BY THE BUYER, EXCEPT THAT THE PRODUCT SHALL BE IN COMPLIANCE WITH THE TECHNICAL SPECIFICATIONS PRESENTED HEREIN.

REVISED 08-15-2002