MATERIAL
SAFETY DATA SHEET
Page: 1
PRODUCT
NAME: YELLOW OXIDE CERAMIC ACRYLIC WATERBASED PRIMER
HMIS
CODES: H F R P
PRODUCT
CODE: 20-13674 1 0 0 J
================== SECTION I
- MANUFACTURER
IDENTIFICATION =================
MANUFACTURER'S
NAME: Pruett-Schaffer Chemical Co.
ADDRESS: 3327 Stafford Street
Pittsburgh PA 15204
EMERGENCY
PHONE: 1-800-633-8253 INFORMATION PHONE: 1-412-771-2000
REVISION
DATE: 08/13/02 NAME OF PREPARER: Robert P. Barry
========== SECTION II
- HAZARDOUS INGREDIENTS/SARA III
INFORMATION =========
VAPOR PRESSURE WEIGHT
REPORTABLE
COMPONENTS CAS
NUMBER mm Hg @ TEMP Deg F PERCENT
----------------------------------------------------------------------------------------
Water
7732-18-5 43.85
Acrylic
Polymers
25586-20-3 0
0 18.80
OSHA PEL: None established
Feldspar,
inert filler 68476-25-5 0 0 15.85
OSHA PEL: None establishd
Yellow
Iron Oxide, inert pigment
51274-00-1 0
0 11.01
ACGIH TLV: 5 mg/m3, OSHA PEL: 10 mg/m3
Crystalline
Silica as Quartz, Sand, SiO2
14808-60-7 0 0 3.96
ACGIH TLV: 0.1 mg/m3. OSHA PEL: 0.1 mg/m3
resp.
2,2,4-Trimethyl-1,3-Pentanediol
Monoisobutyrate 25265-77-4 0.01 77 1.88
None established by OSHA or ACGIH.
*
Calcium Strontium Zinc Phosphosilicate
66402-68-4 0 0 1.19
OSHA PEL: None established
*
Zinc Oxide
1314-13-2 0
0 0.58
ACGIH TLV: 10 mg/m3. OSHA PEL: 10 mg/m3
TWA total dust, 5 mg/m3 respirable
*
Ammonia
1336-21-6 448
15 C 0.09
ACGIH TLV 8 HR: 25ppm, OSHA PEL: 25ppm
PEL, 35ppm STEL 15 MIN
* Indicates toxic chemical(s) subject to the
reporting requirements of section
313
of Title III and of 40 CFR 372.
LEGEND: (C)=Ceiling limit; (S)=Skinlimit;
(STEL)=Short Term Exposure Limit;
(Mppcf)=Million
Particles Per Cubic Foot; (TWA)=8 HR Time Weighted Average.
=============== SECTION III - PHYSICAL/CHEMICAL
CHARACTERISTICS ===========
BOILING
RANGE: 491 deg F SPECIFIC
GRAVITY: 1.32
VAPOR
DENSITY: Heavier than air.
EVAPORATION RATE: Slower than ether.
COATING
VOC: 0.52 lb/gl MATERIAL VOC: 0.22 lb/gl
ORGANIC
SOLVENT, PERCENT BY WEIGHT: 1.984
ORGANIC
SOLVENT, PERCENT BY VOLUME: 2.783
COATING
DENSITY, LB/GAL: 10.978
SOLUBIBLITY
IN WATER: Completely.
APPEARANCE
AND ODOR: Viscous, opaque liquid with an ammonia-like odor.
================= SECTION IV - FIRE AND EXPLOSION HAZARD DATA
=================
FLASH
POINT: Greater than 141 deg F. METHOD
USED: CLEV OC
FLAMMABLE
LIMITS IN AIR BY VOLUME- LOWER: .6
UPPER: 25
EXTINGUISHING
MEDIA: Foam, alcohol foam, CO2, dry chemical, water fog.
SPECIAL
FIREFIGHTING PROCEDURES: Wear self-contained breathing apparatus and
full
protective clothing. Keep onlookers
away. Dike runoff to prevent entry
into
sewers, storm drains, and watercourses.
Notify appropriate state and local
agencies.
MATERIAL
SAFETY DATA SHEET
Page: 2
UNUSUAL
FIRE AND EXPLOSION HAZARDS: Pressure may build up in tightly closed
containers
exposed to fire which may result in rupture.
Keep containers cooled
with
water spray.
========================
SECTION V - REACTIVITY DATA
==========================
STABILITY:
Stable
CONDITIONS
TO AVOID: Excessive heat, freezing temperatures, corrosive
atmospheres
or liquids which may damage containers.
INCOMPATIBILITY
(MATERIALS TO AVOID): No hazardous reactions are expected to
occur
under normal industrial conditions.
HAZARDOUS
DECOMPOSITION OR BYPRODUCTS: Carbon dioxide, carbon monoxide, and
other
toxic gases including traces of styrene and/or acrylamide monomer.
HAZARDOUS
POLYMERIZATION: Will not occur.
==================== SECTION VI
- HEALTH HAZARD DATA =======================
INHALATION
HEALTH RISKS AND SYMPTOMS OF EXPOSURE: Effects vary among individuals
and
may include nausea and irritation of the nose, throat, and respiratory
tract.
SKIN
AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE: Eye contact may
cause
irritation, redness, and tearing. This
material is not expected to be a
skin
irritant, however, if allowed to remain on the skin a thin film may form
which
may result in irritation depending on the method of removal.
INGESTION
HEALTH RISKS AND SYMPTOMS OF EXPOSURE: While this material has a very
low
degree of toxicity, ingestion of large amounts can cause gastrointestinal
irritation,
vomiting, nausea, and diarrhea.
HEALTH
HAZARDS (ACUTE AND CHRONIC): Breathing high concentrations of aerosols or
mists
of this material may cause nausea and irritation of the nose, throat, and
respiratory
tract. NOTE: this product contains
trace amounts of residual butyl
acrylate
(CAS 141-32-2, TLV = 10 ppm ACGIH, OSHA) and styrene monomer (CAS 100-
42-5,
TLV = 50 ppm ACGIH) which may be released during processing and storage.
At
these trace levels, they should present no hazard with normal use.
CARCINOGENICITY: NTP: Yes
IARC MONOGRAPHS: Yes OSHA
REGULATED: No
CHRONIC
EFFECTS OF CRYSTALLINE SILICA AS QUARTZ
The
International Agency for Research on Cancer (IARC) has evaluated crystalline
silica,
inhaled as quartz, and classified it as a confirmed human carcinogen.
The
National Toxicology Program (NTP) classifies quartz as "reasonably
anticipated
to be a human carcinogen".
MEDICAL
CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Respiratory symptoms
associated
with pre-existing lung disorders may be aggravated by exposure to
this
material.
EMERGENCY
AND FIRST AID PROCEDURES: INHALATION OVEREXPOSURE: Remove person to
fresh
air, If breathing stops, apply artificial respiration and seek immediate
medical
attention. NOTE: Use supplied-air
respirator for rescue in enclosed
areas. EYE CONTACT: Flush with large amounts of
tepid water for at least 15
minutes,
get medical attention. INGESTION: Do
not induce vomiting, if aspirated
material
can cause chemical pneumonitis or pulmonary edema. Drink 2 glasses of
milk
or water to dilute and contact physician or poison center. SKIN: Wash with
soap
and water, avoid repeated contact.
MATERIAL
SAFETY DATA SHEET
Page: 3
=========== SECTION VII
- PRECAUTIONS FOR SAFE HANDLING
AND USE ============
STEPS
TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Dike to prevent entry
into
sewers or surface waters. Recover free
liquid by shoveling into container,
or
add absorbant such as sand or earth to spill and sweep up. Provide
ventilation,
wear a respirator. Notify proper
authorities if spill contaminates
land
or waterways.
WASTE
DISPOSAL METHOD: Dispose of in chemical landfill or incinerate assuring
conformity
to all applicable local, state, and federal governing regulations.
PRECAUTIONS
TO BE TAKEN IN HANDLING AND STORAGE: Do not expose to direct sun or
freezing
temperatures, store inside away from extreme temperature variations.
Protect
containers from physical damage. Keep
containers tightly closed when
not
in use. Do not inhale vapors or mists,
use with adequate ventilation and
wear
a respirator. Do not store with food or
animal feed.
OTHER
PRECAUTIONS: Do not cut, weld, grind, drill, solder, or braze on or near
containers
whether full or empty. Do not reuse
containers without professional
reconditioning
and testing. Do not remove warning
labels from containers.
===================== SECTION VIII - CONTROL MEASURES ======================
RESPIRATORY
PROTECTION: Using this product in poorly ventilated areas may
require
the use of a respirator. Use Mine
Safety Appliance respirator #448849
with
organic vapor cartridge and mist filter (or equivalent) if air monitoring
demonstrates
that the concentration of listed hazardous materials exceeds the
recommended
TLV's. In enclosed areas where
ventilation is not used, wear a Mine
Safety
Appliance #475217 pressure/demand air-supplied respirator or equivalent.
VENTILATION:
Use good general mechanical ventillation and local exhaust adequate
to
reduce the concentration of vapors or mists of the listed hazardous materials
to
below the Threshold Limit Value(s).
PROTECTIVE
GLOVES: Use of gloves is recommended, use chemically resistant type.
EYE
PROTECTION: Use is recommended, use splash goggles or full face shields as
necessary.
OTHER
PROTECTIVE CLOTHING: Use impervious apron or coveralls to prevent
contaminating
streetclothes which may result in prolonged exposure. The use of
head
caps or helmets is recommended.
WORK
AND HYGIENIC PRACTICES: Eye washes and safety showers in the workplace are
recommended. Practice good industrial hygiene when using
this product: After
using
this product, do not smoke or eat until washing thoroughly. Remove
saturated
clothing or shoes at once and launder before reuse.
======================= SECTION IX
- MISCELLANEOUS =========================
DOT
INFORMATION:
DISCLAIMER:
The
information and recommendations contained herein were believed to be
accurate
at the time of preparation or obtained from sources believed to be
generally
reliable. Direct testing of this
product under all conceivable
conditions
of use has not been done. Information given herein is given in good
faith,
however Pruett-Schaffer Chemical Corporation makes no warranty concerning
its
accuracy and will not be held liable for claims relating to any party's use
of
or reliance on this information.